Wireless Controls and Automation

Industrial Wireless Radio Controls 

Transmitter & Receiver   943301

3 km (2 Miles)   line-of-sight w Yagi antenna
Operation:  120/240VAC or 12VDC
Transmitter input N/O Dry contact
Relay Output SPDT, 6A Class 2 pilot duty
Heavy Duty NEMA4, IP65 UL Fiber enclosure
License free 430 - 450MHz Industrial ISM band
Factory configured systems, Ready to operate
No setup or programming required
                                                                                       .Please request a quotation

 Operation each channel  Transmitter Receiver

     Start Stop Mode
Close switch Ch 1
Open switch Ch 1

Close switch Ch 1
Close switch Ch

Relay 1   ON
Relay 1  OFF

Relay 1   ON
Relay 1   OFF

   Specifications      Digital Transmitter
Supply power 120/240VAC or 12VDC /  8watt 
Inputs  N/O Normally Open, digital dry contact
Transmitter power per FCC Part 15.249,  50mV/m @ 3m
Transmission Digital Encoded   Gaussian_frequency-shift_keying
Channels 16 addresses per system  GFSK
Input Wiring Din Terminals,  Dry Contact
Response Loop 500 msec
Weight 12 lb (5.40kg)  each unit
Dimensions * 12"W x 8"H x 4"D (300 x 200 x 100 mm) * may vary

   Specifications      Digital Receiver 
Supply power 120/240VAC or 12VDC /  5watt 
Output   Relay 6Amp, Class 2 pilot duty
Frequency 433 MHz  • License free Industrial ISM band
Configuration DIP switch factory preset
Compliance FCC CFR part 15.247, 95 sub E
Wiring Screw Terminals
Antenna Z 50 Ohm SMA RF connector
Ambient temp  14 to 140 F (-10 to 60 C)
Enclosure  NEMA4, IP65 Fiber UL listed

3 Element Beam  Yagi Antenna


3 Element Beam  Yagi Antenna
433 MHz, Gain: 7 dBi  Rating: 150 Watts
Impedance 50 ohms N terminal
Vertical beam 45 degrees - Horizontal beam 60 degrees
Base Length: 18", Weight: 1.0lb

Yagi Antenna w 12ft Coax Cable & RF Connector


Special Options:


■ Fail Safe sequence module
■ Momentary contact closure (pulse)
■ Battery Backup module
■ Low Battery Alarm
■ Latching Mode 
■ OFF or ON Delay timer
Start Stop Module w Fail Safe Class 2
■ High, Low Status level indicator lamp

Optional Solar power pack


Radio control equipment in not to be used in life safety.
Radio Installations shall be performed by a certified professional.


  Wireless Range from: 3 Km   (2 Miles )
Optional Extended range up to to 16 Km (10 Miles)

Industrial Monitoring, Pump control, Monitor remote instruments, sensors,
Lighting control, Packing and mobile system, PLC remote, SCADA,
Factory process control,  Alarms, Generators,  Solar,  Wire replacement.

   .Please request a quotation

   Part #    Channel    

943301   Single (1)
943302   Two  (2)   
943304   Four (4)  
  Basic Package include: 
One  Base Transmitter, One  Base Receiver 
Two Yagi 938432 Antennas with 12ft coaxial cable,
NEMA 4 Fiber enclosures & Instructions

     Application Example Single Channel Control

      943381  Single Channel Wireless Control

          943382  Two Channel Wireless control with Start Stop Module


    Typical pump application
     Remote Command & Monitor

Long range with Battery Backup system 6010




     Copyright   Electrodepot. All rights reserved